How you can Fit A Reusable Hydraulic Hose Fitting

Issues do arise though, specially when considering a piece of equipment that can cause devastating failure whether it’s improperly installed. That’s the case with hydraulic hose fittings, which are integral to the successful procedure of countless machines around the world. If fitted incorrectly, these fittings can leak, detach or (in the most extreme cases) snap off entirely.

To begin, we’ll have to have a few things; a hose cutter, an open up ended wrench (in the diameter of your fitting), a vice and lubrication. Minus the right size wrench, use a goof wrench instead, ensuring you have got a good hold on the fitting.

1st, get your length of hydraulic hose and line cutter. There’s a good chance that the line will have been reduce straight in the manufacturing plant but we’re still heading to give it a trim. Get your line cutter and make a straight, clean cut at the top of the hose, just taking enough off to level it out. Now, thread your outside collar in to the line, using your wrench to show it counter-clockwise as you go. Ensure not to over-tighten the outside training collar by looking into the fitting, the hose should just touch the bottom, and not overlap any threading inside the chamber.

After that, place the collar and hose into a bassesse and lubricate your fitted. This is actually the difficult part, as getting the stems to line up isn’t easy. That said, if if you’re really forcing it, if you’re likely doing it incorrect and should start again. Begin tightening the fitted inside the collar and keep going until you approach the point where they’re within touching distance. At this point, do NOT tighten any further. Having these two items touching is over-tightened and can lead to leakages and breakages, leave a little gap for safety.

Hydraulic wrenches range from the most common household types to specialty types.Check out the website that specializes in wrenches at https://www.atwwren.com for details.
Or contact us
Company Name: Hang Zhou WREN Hydraulic Equipment Manufacturing Co., Ltd.
Address: No. 24, Xingxing Road, Linping, Hang Zhou, China
Tel: +86 571 8811 5720
Fax: 0571-88110210
Postcode: 311100
E-mail: info@wrenchina.com